Separate Inner Bucket Structure Water Purifier Bottle Multi Level Filtration System

Separate Inner Bucket Structure Water Purifier Bottle Multi Level Filtration System

OPERATION GUIDE

1. Open box and remove all contents

2. Unscrew the filter base and cover the filter parts in cold water and

let them soak for 30 minutes

3. Wash the two half’s of the bottle with soap and cold water before the

first use and wash regularly there after

4 .Assemble the filter except the ceramic disk. Place the silicone ring

around the neck of the filter as shown in diagram.

5. Assemble the two half’s of the bottle and place the filter in the top

bucket, push down firmly to avoid leakage. Now screw on the filter mask

6.Place the bottle in sink, fill the top bucket with water and let it

drain away.

7. When the water has drained away remove filter from bottle. Now place

the silicone ring and ceramic disk on base of filter, screw cover onto

filter bottom.

8.Rinse lower bucket and assemble bottle, Place filter in the top

bucket as before. Now place bottle on water dispenser and fill the top

bucket.

9. Never have both top and bottom buckets filled at the same time.

When to change your filter

It is important to change the filter before it is exhausted. It is recommended to replace your filter approximately every 6 months or 2000L which ever comes

Cleaning your water filtration system .

• The outside of water bottle can be wiped of with a damp cloth at any time
• When the filter is being replaced you should lightly wash and rinse the inside of the bottle

Being away for a long time

• When not using the water filtration system for more than a week or going on vacation, always drain out any residual water before using again. Never empty the outer bucket before going away as the Multi-Level Filter dries out.

Useful tips & precautions :

• Never filter hot water or use it to clean your filter
• Never remove the water filtration system bottle to fill at the sink
• Always use a pitcher to fill

This unit is not diswasher safe

The water filtering speed can become a little slow when the quantity of water in the outer bucket increase

Dirty ceramic Dirty ceramic disc also cause a decrease in speed.

Keep your uni

Keep your unit in a dry place and out of direct sunlight.

Please make Please make sure to clean the inner bucket regularly to avoid dirt and calcium build up

Products Sketch drawing :

Products Test reports :

Contact details :

NINGBO GOOD WATER SOURCE ENVIRONMENTAL PROTECTION ELECTRICAL APPLIANCE CO.,LTD

Contact person: Jack Liu

Contact e-mail: jackliu_qingqing@vip.126.com

Contact phone: (86) 13884494576

Skype: jackliu06316

Wechat: Jackliu8886

Dirt and

This unit

Never wat

Never filter h

Useful Tips

The outside o

first.

1/ Remove up